Asset Tracking: Choosing GPS, BLE and Cellular for Location
Asset tracking covers everything from shipping containers crossing oceans to equipment moving between rooms in a hospital. No single location technology covers that range. Satellite positioning works outdoors, Bluetooth LE works indoors with infrastructure, and cellular networks provide both a coarse position and the link to report it. This article compares the options and shows how they are combined in practice.
At a glance
- GNSS
- GPS, Galileo, GLONASS and BeiDou. Multi-constellation receivers find fixes more reliably.
- Outdoors
- Satellite signals are weak and rarely usable deep inside buildings.
- Beacons
- BLE tags and fixed BLE receivers give room or zone level location indoors.
- Cell ID
- The serving cell gives a coarse position with no extra hardware.
The problem
Teams often start with GNSS because it is familiar, then find that assets spend most of their time indoors, in vehicles or stacked in containers, where fixes fail or take a long time. A receiver left searching for a fix is also one of the largest energy costs in a tracker.
Bluetooth LE solves indoor location only where receivers or beacons are installed, and its accuracy depends on how densely they are placed. Cellular provides a link almost everywhere but only a coarse position on its own.
Start from where the asset spends its time and what question the location must answer. Precision nobody uses costs battery.
Combining methods
A practical tracker often uses several methods in order of cost. It reports the serving cell or nearby Wi-Fi access points first, attempts a GNSS fix only outdoors or when movement is detected, and uses Bluetooth LE near known infrastructure. Wi-Fi and cell positions rely on a lookup service whose cost and coverage vary by provider.
Assistance data downloaded over cellular, known as A-GNSS, shortens the time to first fix considerably. An accelerometer that keeps the device asleep while the asset is stationary is often the largest single saving.
What good looks like
Map where assets go and how long they spend in each place, and define the accuracy and update rate needed in each.
Choose a primary method and a fallback for each environment, then decide what triggers a location attempt: time, motion or a geofence event.
Field test on real routes and sites, recording fix success, time to fix and energy per location before committing the design.
| Method | Works | Typical accuracy | Needs |
|---|---|---|---|
| GNSS | Outdoors, open sky | A few metres | Receiver, antenna and time for a fix |
| Bluetooth LE signal strength | Indoors, near infrastructure | Zone or room level | Installed beacons or gateways |
| Wi-Fi scanning | Mostly indoors and urban areas | Tens of metres | A lookup service |
| Cellular cell ID | Wherever there is coverage | Hundreds of metres to kilometres | Cellular modem and a lookup service |
| Ultra-wideband | Indoors, near anchors | Decimetre level | Installed anchors |
| GNSS | Bluetooth LE | |
|---|---|---|
| Works indoors | Rarely | With infrastructure |
| Infrastructure needed | None | Beacons or gateways |
| Energy per location | Higher | Lower |
| Coverage area | Global | Where installed |
What it changes
Coverage
Assets are located indoors and outdoors with the method suited to each place.
Battery Life
Expensive fixes happen only when motion or schedule makes them useful.
Fit for Purpose
Accuracy matches the business question, such as which site or which room.
Known Costs
Data plans and lookup services are budgeted from the start.
Where to go next
For precise indoor positioning, Bluetooth direction finding and Channel Sounding, or ultra-wideband, offer better accuracy at the cost of more infrastructure.
Plan for roaming early if assets cross borders. Cellular IoT coverage and roaming agreements vary by network and region.
Problems this prevents
- GNSS searching indoors until the battery fails
- Accuracy far beyond what the business needs
- Indoor zones with no BLE infrastructure
- Roaming gaps on cross-border routes
Discuss your project
Email support@aavico.com or use Get in Touch when the website finishes loading.