Buck Converter Layout: Keeping the Hot Loop Small

A buck converter that measures well on its evaluation board can misbehave on a custom one: ringing on the switch node, output noise, unstable regulation or a failed emissions test. The cause is usually the layout of a single current loop, the one that carries pulsed current through the input capacitor and the switches. This article explains which loop that is, why its inductance matters, and how to place parts to minimise it.

At a glance

V = L di/dt
The voltage developed across a loop inductance by a changing current.
1 A/ns
A current changing at this rate develops 1 V across every nanohenry of loop inductance.
Input cap
The small ceramic input capacitor closes the hot loop and belongs right at the switch pins.
SW node
The switching node: keep its copper small, since it radiates and couples noise.

The problem

In a buck converter the inductor current is continuous, but the input current is not. It jumps between zero and the full inductor current every switching cycle, with transitions lasting nanoseconds. The loop it flows through, from the input capacitor through the high-side and low-side switches and back, is called the hot loop.

Any inductance in that loop turns those fast transitions into voltage spikes and ringing on the switch node. The spikes stress the switches, couple noise into nearby circuits and radiate at frequencies far above the switching frequency.

Place the input capacitor first and build the converter around it. The hot loop is decided in the first minutes of layout.

Placement that works

Put a small ceramic input capacitor as close as possible to the converter’s input and ground pins, on the same layer, so the hot loop spans only a few millimetres. A solid ground plane on the next layer down lets the return current flow directly beneath the loop and reduces its inductance further.

The inductor carries steady current, so its connections are less critical, but keep the switch-node copper only as large as current and cooling require. Route the feedback trace from the output capacitor away from the inductor and switch node, and take it from the point where regulation matters.

What good looks like

Identify the hot loop from the converter datasheet: input capacitor, switches and ground return. Many datasheets include a recommended layout.

Place the input capacitor and converter first, then the inductor, then the output capacitors, then the feedback components.

Measure the switch node with a short ground connection on the probe and compare the ringing peaks against the switch voltage ratings.

Voltage spike for a 1 A/ns current change
V
1 nH1
3 nH3
5 nH5
10 nH10
20 nH20
Calculated from V = L di/dt. Real waveforms ring, but the scaling holds.

Placement order

  1. Input capacitor: At the input and ground pins
  2. Converter: Switches beside the capacitor
  3. Inductor: Short link from the switch node
  4. Output capacitors: Return to the same ground
  5. Feedback: Quiet route from the output
Placing in this order keeps the hot loop small before anything else competes for space.

What it changes

Lower Ringing

A small loop means smaller spikes on the switch node.

Better EMC

Reduced loop area cuts radiated and conducted noise.

Stable Regulation

Feedback kept away from noisy nodes keeps the control loop clean.

Component Margin

Switches see less voltage overshoot, improving reliability.

Where to go next

Follow the datasheet reference layout closely. The pinout was designed for exactly this problem.

Measuring switch-node ringing needs a short probe ground. A long ground lead adds its own inductance and shows ringing that is not on the board.

Problems this prevents

  • Input capacitors placed far from the switches
  • Large switch-node copper that radiates
  • Feedback traces routed past the inductor
  • Ringing misread through a long probe ground

Discuss your project

Email support@aavico.com or use Get in Touch when the website finishes loading.