Design for Manufacturing: The Numbers Fabricators Work To

Every fabricator has a set of capabilities: the narrowest trace they can etch reliably, the smallest hole they can drill and plate, the closest they will bring copper to the board edge. Designs inside the standard capability go through normal production. Designs at the edge need special processing, cost more and yield less. This article lists typical figures and explains how to use them.

At a glance

0.15 mm
A widely available standard minimum for trace width and spacing (about 6 mil).
0.3 mm
A common standard minimum for a finished plated hole.
10:1
A typical upper limit for the ratio of board thickness to drilled hole diameter.
0.25 mm
A common minimum clearance from copper to the board edge.

The problem

Layout tools will let you draw almost anything. Nothing stops a designer using a 0.1 mm trace everywhere or placing a via under a pad without filling it, and the consequences appear weeks later as a query from the fabricator, a price increase or a batch of marginal boards.

The limits also interact. A small hole in a thick board has a high aspect ratio and is hard to plate, even though both the hole size and the thickness are individually acceptable.

Design to the standard capability and use the advanced one only where the design truly needs it.

Using these figures

The numbers in the table are typical of widely available services, not a specification. Capabilities differ between fabricators and between their standard and advanced processes, so obtain the design rules from the supplier you intend to use and load them into your layout tool.

Where a tight feature is unavoidable, such as the breakout of a fine-pitch BGA, confine it to that area and keep the rest of the board relaxed.

What good looks like

Get the capability sheet from your chosen fabricator and assembler before layout begins.

Enter those limits as design rules so the layout tool flags violations as you work.

Run a design-for-manufacturing check before release and resolve every finding, or agree it with the supplier in writing.

Typical fabrication capabilities
FeatureStandardAdvanced
Trace width / spacing0.15 mm (6 mil)0.10 mm (4 mil) or less
Finished plated hole0.3 mm0.2 mm or less
Annular ring0.15 mm0.10 mm
Hole aspect ratioUp to about 8:110:1 and above
Copper to board edge0.25 mm0.20 mm
Solder mask dam0.10 mm0.075 mm
Representative of widely available services. Always use your own fabricator’s published rules.
Standard and advanced trace width
mm
Relaxed0.2
Standard0.15
Advanced0.1
HDI0.075
Typical minimum trace widths, in millimetres.

What it changes

Yield

Features inside standard capability are produced reliably, batch after batch.

Cost

Avoiding advanced processes keeps the board in the lowest price band it can occupy.

Lead Time

A clean data package passes through engineering review without queries.

Portability

A board that does not depend on one supplier’s limits can be moved to another.

Where to go next

Review assembly constraints as well: component spacing, fiducials, panel rails and the clearance needed around tall parts.

Send the fabricator your stackup and impedance needs with the request for quotation, so their review covers everything at once.

Problems this prevents

  • Trace and space below the supplier’s standard
  • High aspect-ratio vias that plate poorly
  • Copper too close to the board edge
  • Engineering queries that delay every order

Discuss your project

Email support@aavico.com or use Get in Touch when the website finishes loading.