Embedded System Design: Building Reliable Hardware and Software Together

In an embedded product, every hardware choice is a software constraint and every software feature is a hardware cost. A cheaper microcontroller limits memory; a new feature raises current draw; a late change to a sensor ripples through drivers, tests and the enclosure. Teams that plan the two sides together make these trade-offs on purpose. This article follows the path from requirements to production and points out where those trade-offs are decided.

At a glance

Requirements
Performance, power, cost and size targets agreed before components are chosen.
Architecture
Hardware and firmware partitioned together, with interfaces defined early.
Testing
Verification planned from the start, from unit tests to hardware-in-the-loop.
Production
Design for manufacture and factory test considered during layout, not after it.

The problem

Embedded systems have to do a defined job within fixed limits on processing, memory, energy and cost, often for years without attention. There is little room to fix an architectural mistake with a bigger part once the board and enclosure exist.

The difficulty is that the important decisions are interdependent. Component selection, power design, firmware architecture, security and test strategy each constrain the others, and requirements tend to move while all of this is happening.

Every hardware decision is a firmware constraint. The trade-offs are cheapest when both sides are in the same conversation.

What good looks like

A system specification covering function, performance, power budget, security, size, cost and compliance, with priorities stated for when they conflict.

Hardware architecture, component selection with second sources where possible, schematics, PCB layout and prototypes built to answer specific questions.

Firmware architecture, drivers and application code, a security approach, and the test firmware and procedures needed for bring-up and for the factory.

What it changes

Engineering Impact

Trade-offs between hardware and firmware are made explicitly and recorded, rather than discovered at integration.

Performance Impact

Memory, processing and timing budgets are tracked from the start, so real-time behaviour is designed in.

Reliability Impact

Testing at each stage finds defects while they are still local and inexpensive to fix.

Production Impact

Component availability, manufacturability and factory test are settled before the design is released.

Where to go next

With the architecture proven on a prototype, the work becomes disciplined iteration: test, refine, document and prepare the design for manufacture.

Requirements will change. An architecture with clear interfaces and some headroom in memory and power absorbs new features without a restart.

Problems this prevents

  • Requirements that outgrow the chosen hardware
  • Hardware and firmware developed in isolation
  • Tight power, memory and timing budgets
  • Bring-up, debugging and factory test left to the end

Discuss your project

Email support@aavico.com or use Get in Touch when the website finishes loading.