IPC Class 1, 2 and 3: Which Quality Level Does Your Product Need?
When you order boards or assembly, the IPC class tells the manufacturer what acceptance criteria to work to. It is one of the most consequential lines on a purchase order and one of the least understood. A higher class is not simply better: it tightens tolerances and inspection, which raises cost and lead time. This article explains what the three classes mean and how to decide.
At a glance
- Class 1
- General electronic products, where function is the main requirement.
- Class 2
- Dedicated service products, where continued performance and long life matter.
- Class 3
- High-reliability products, where downtime or failure is not acceptable.
- IPC-A-610
- The acceptability standard for assembled boards; IPC-6012 covers bare rigid boards.
The problem
Many orders specify no class at all, and the manufacturer applies their default, usually Class 2. Others ask for Class 3 because it sounds safest, without designing the board to meet Class 3 rules, so the request cannot actually be fulfilled.
The class has to be decided at design time. Class 3 affects annular ring size, plating thickness and other geometry, so a layout designed to Class 2 rules may not be buildable to Class 3.
The class is a design input. Deciding it at the purchase order is too late.
Choosing a class
Most commercial and industrial products are Class 2. Choose Class 3 when a failure in service has serious consequences or the product cannot be repaired, as in many aerospace, medical life-support and critical industrial systems.
Whichever class applies, state it on both the fabrication and the assembly documentation, and make sure the design rules used in layout correspond to it.
What good looks like
Decide the class from the consequences of failure and the expected service life, with input from any customer or regulatory requirements.
Set the layout design rules to match, including annular rings and hole sizes.
State the class and the applicable IPC standards on the fabrication drawing and the assembly instructions.
| Class | Name | Typical products |
|---|---|---|
| 1 | General electronic | Consumer goods where function is the main requirement |
| 2 | Dedicated service | Industrial controls, communications and most commercial equipment |
| 3 | High reliability | Aerospace, life-support medical and critical systems |
Where the class takes effect
- Requirements: Consequence of failure, service life
- Layout rules: Annular rings, hole and trace geometry
- Fabrication: IPC-6012 acceptance
- Assembly: IPC-A-610 acceptance
- Inspection: Evidence the class was met
What it changes
Reliability
The build standard matches what the product has to survive in service.
Cost Control
You pay for tighter tolerances and extra inspection only where they are justified.
Clear Acceptance
Supplier and customer judge the boards against the same written criteria.
Fewer Disputes
A stated class settles what counts as a defect before the first board is built.
Where to go next
Ask suppliers which class they build to by default and what evidence they provide, such as inspection reports or cross-sections.
For regulated products, check whether an industry-specific addendum applies in addition to the base standard.
Problems this prevents
- No class stated on the order
- Class 3 requested for a Class 2 layout
- Paying for inspection the product does not need
- Disagreements over what counts as a defect
Discuss your project
Email support@aavico.com or use Get in Touch when the website finishes loading.