PCB Surface Finishes Compared: HASL, ENIG, OSP and More

Bare copper oxidises within days, and oxidised copper does not solder. Every board therefore ships with a finish over its exposed pads. The choice affects assembly yield, how long boards can be stored, and whether the finish is suitable for fine-pitch components, edge connectors or wire bonding. This article compares the finishes you will be offered and gives a way to choose.

At a glance

ENIG
Electroless nickel immersion gold: flat, durable and the common default for fine-pitch work.
HASL
Hot air solder levelling: economical and robust, but uneven on small pads.
OSP
Organic solderability preservative: flat and low cost, with the shortest storage life.
RoHS
Lead-free finishes are required for products sold under RoHS rules.

The problem

Hot air levelling leaves a slightly domed, uneven coating. On large pads that does not matter. Under a fine-pitch BGA or a 0.4 mm pitch QFN, the height variation between pads causes opens and bridges.

Flat finishes solve that but each has a weakness: OSP degrades with handling and repeated heating, immersion silver tarnishes if stored badly, and ENIG costs more and needs a well-controlled process.

Choose the finish for your finest-pitch part and your storage time. Everything else on the board will be fine with it.

How to choose

If the board has BGAs, fine-pitch QFNs or other parts with pitch at or below 0.5 mm, choose a flat finish; ENIG is the usual choice. If everything is larger and cost matters most, lead-free HASL is a sound option.

If boards will sit in storage before assembly, check the shelf life of the finish with your fabricator and keep boards in their sealed packaging until use.

What good looks like

Find the finest-pitch component and any special requirements such as edge fingers, press-fit connectors or wire bonding.

Choose the lowest-cost finish that meets those requirements and the expected storage time.

Specify the finish on the fabrication drawing and tell the assembler, since it affects their reflow settings.

Finishes at a glance
FinishSurfaceFine pitchRelative cost
Lead-free HASLUnevenLimitedLow
OSPFlatGoodLow
Immersion silverFlatGoodMedium
Immersion tinFlatGoodMedium
ENIGFlatVery goodHigher
ENEPIGFlatVery good, wire-bondableHighest
Typical characteristics. Shelf life and cost vary by fabricator and storage conditions.
HASL and ENIG, side by side
Lead-free HASLENIG
CostLowerHigher
Pad flatnessUnevenFlat
Fine-pitch and BGALimitedWell suited
Rework toleranceRobustGood
StorageGoodLong
The two finishes most boards choose between.

What it changes

Assembly Yield

A finish matched to the pad geometry removes a common cause of opens and bridges.

Shelf Life

Boards stay solderable for as long as the build plan needs.

Cost

The premium for a flat finish is paid only where the design requires it.

Compliance

A lead-free finish keeps the bare board within RoHS requirements.

Where to go next

Edge connectors that are plugged repeatedly need hard gold on the contact fingers, which is specified separately from the board finish.

If your assembler reports solderability problems, check the board date code and storage conditions before changing the finish.

Problems this prevents

  • Bridging under fine-pitch parts from an uneven finish
  • Boards that will not solder after long storage
  • Paying for ENIG on a board that does not need it
  • A leaded finish on a RoHS product

Discuss your project

Email support@aavico.com or use Get in Touch when the website finishes loading.