PCB Surface Finish Selection Guide

HASL, lead-free HASL, ENIG, ENEPIG, immersion silver, immersion tin, OSP and hard gold compared, with a selection flow

The surface finish protects exposed copper until assembly and becomes part of every solder joint, contact and wire bond on the board. The right choice depends on component pitch, the soldering process, storage time, contacts and bonding, the operating environment and cost. This guide puts those trade-offs side by side so the decision can be made early and written clearly on the fabrication drawing.

Shelf lives and costs here are typical and relative; they vary with the chemistry supplier, packaging and storage conditions. Agree the finish with both your fabricator and your assembler, since the assembler's process is often what decides between two otherwise suitable finishes.

What is inside

  • What a surface finish must do and the factors that drive the choice
  • Profiles of HASL, lead-free HASL, ENIG, ENEPIG, immersion silver, immersion tin, OSP and hard gold
  • A comparison table of flatness, shelf life, wire bonding, cost, lead-free use and typical uses
  • A step-by-step selection flow
  • Common finish-related defects and how to avoid them
  • A checklist for specifying the finish on the drawing

Contents

  1. What drives the choice
  2. Finish profiles
  3. Comparison table
  4. Selection flow
  5. Finish-related defects
  6. Specifying the finish
  7. Notes and limits

Formats: PDF document. Sign in to download for free.

Related courses

Discuss your project

Email support@aavico.com or use Get in Touch when the website finishes loading.