Via and Drill Reference
Via types, finished and drilled sizes, aspect ratio, annular ring, IPC-4761 protection, microvias, back-drilling and typical drills
Holes drive cost, yield and reliability more than most designers expect. This reference gathers the concepts and the typical numbers you need when you set up drill rules and via styles, and when you write the drill and via notes on the fabrication drawing.
Values marked typical are common starting points across many fabricators, not limits from a standard. Before you commit to a via size, check it against your fabricator's capability for your board thickness and class, and confirm the protection type they recommend for your assembly process.
What is inside
- Via types from through vias to stacked microvias
- Finished versus drilled hole size, tolerances and plating
- Aspect ratio guidance with a worked table
- Annular ring design and IPC-6012 class differences
- IPC-4761 via protection Types I to VII with uses
- Microvia and back-drilling basics
- Typical drill and pad sizes for common uses
Contents
- Via types
- Finished versus drilled hole size
- Aspect ratio
- Annular ring
- Via protection: IPC-4761 types
- Microvias and back-drilling
- Typical drill sizes for common uses
- Notes and limits
Formats: PDF document. Sign in to download for free.
Related courses
Discuss your project
Email support@aavico.com or use Get in Touch when the website finishes loading.